The ARM6Z series intelligent measurement circuit breakers are available in 400A and 630A case frames

2023-11-14

Functional Summary

ARM6Z series intelligent measuring Circuit Breaker, suitable for AC 50Hz/60Hz rated working current 125A to 250A, rated insulation voltage 1000V, rated working voltage AC380V distribution protection.

The measuring switch has the functions of long delay, short delay, instantaneous, over and under voltage and phase break protection, which protects the line and power supply equipment. It has the current, voltage, power, electric energy and other information of feedback products to the terminal equipment and the accuracy reaches the meter level, which is used to detect and monitor the load end, reduce the operation and maintenance cost of the power grid, and provide the necessary data for the future energy efficiency system.

The measuring switch also has the functions of automatic identification of distribution network topological relationship, error monitoring of watt-hour meter and power line carrier communication.

The technical specifications of the intelligent measurement switch controller are as follows

Protection function	Current protection	With overload long delay, short delay, short circuit instantaneous protection
	Voltage protection	Over-voltage and under-voltage protection
	Phase loss protection	Be equipped with
Measuring function	Electric current	0.004In≤I<0.01In, accuracy ±0.75%:
	Electric current	0.01In≤I≤Imax, accuracy ±0.5%
	voltage	0.65Un≤U≤1.2Un, accuracy ±0.5%
	frequency	45Hz~55Hz, accuracy ±0.01Hz
	power	Active power: ±0.5%, reactive power: ±2%, apparent power: ±2%
	Power factor	Resolution: 0.001,0.5-1.00, error limit: ±0.005
	Electric quantity	Total and separate phase forward, reverse active energy and combined active energy
	Electric quantity	Measurement accuracy meets 0.5S level
Monitoring function	On-off state	Closing position, opening position, tripping position
Topological function	topology	It has the function of topology signal transmission and recognition
Four-remote function	Remote signaling	Switch bit, bit, trip bit, fault remote message
	Remote control	Supports remote delivery of trip commands
	telemetry	Electric parameters such as current, voltage, power and quantity
	Remote regulation	Supports remote setting of switch operation parameters
Communication function	RS485	2 channels, 1200-9600 BPS, support up and down
	HPLC	1 channel, 2-12MHz, support national network interconnection
	Bluetooth	Route 1, BLE5.0
	Communication protocol	DL/ T645-2007, DL/T698, Modbus, etc
Advanced function	Pulse output	Active pulse, reactive pulse, second pulse
	Fault memory	Current overload, short circuit, voltage failure, etc
	Power failure report	The carrier is reported within 60 seconds after a power failure.
	Temperature monitoring	Support inlet and outlet joint temperature monitoring
	Temperature monitoring	Support switch internal temperature monitoring
	Remote output	Support a variety of optional remote control output

Note :
1. Power, electricity measurement function needs to be connected to N line;
2. The product needs to be connected to N line when it is fully functional;
3. Remote output is optional;
4. Temperature monitoring is optional;
5. Communication protocols support DL/T645 protocols by default, and other protocols can be customized according to customer requirements;
6. Electronic music protection and phase-out protection are optional functions.